Charging - Silvercrest SAST 18 A1 Operating Instructions Manual

7) Place the barrel plug
from below. Secure the barrel plug
8) Plug the mains adapter

Charging

NOTE
► Check to ensure that the On/Off switch
position "OFF") before starting the charging process.
■ Hang the appliance into the wall bracket
wall bracket
barrel plug
charge indicator lamp
■ When charging is complete, which can take around 5 to 5.5 hours with fully
discharged batteries, the charge indicator lamp
appliance automatically switches to trickle charging. Nevertheless, in order
to avoid possible damage to the batteries, do not leave the appliance
permanently connected to the mains adapter
■ Recharge the batteries again if the appliance's suction power becomes
appreciably weaker and the charge indicator lamp
NOTE
► If the charge indicator lamp
battery is almost completely discharged and the appliance switches off
after approx. 1 minute. This protects the appliance from deep discharge.
► The appliance can also be charged directly via the mains adapter
do this, remove the barrel plug
twist and insert it into the socket on the appliance.
► The appliance cannot be operated during charging.
SAST 18 A1
9
of the power adapter
0
into a power socket.
7
should slide into the recesses on the motor unit
9
into the socket on the lower end of the motor unit
w
flashes red and the charging process begins.
w
flashes alternately green and red, the
9
0
into the wall bracket
9
by turning it.
q
has been pushed back (to the
7
from above. The catches on the
w
lights up green. The
0
.
w
flashes green.
7
from the wall holder
7
r
and the
r
. The
0
. To
with a slight
GB │ IE │
11 ■