Recording Features; Timer Recording; Express Timer Programing - JVC HR-J694EU Instructions Manual

– Recording –

Recording Features

Specifying recording length
— Instant Timer Recording (ITR)
During recording, press REC (
recording length you want appears on the display panel. The
record indicator ( ) on the display panel starts blinking.
● Each time you press the button, recording length increases in
30-minute intervals (up to 6 hours).
● The VCR shuts off after recording is finished.
● To cancel an ITR, press STOP (
( ) on the VCR.
0
Watching one program while recording another
During recording...
● If you connect the TV and the VCR only using the RF
connection to view pictures from the VCR, press TV/VCR on the
Remote so that VCR mode indicator goes off from the display
panel. (The TV broadcast being recorded disappears.)
● If you are using the AV connection to view pictures from the
VCR, change the TV's input mode from AV to TV.
Then, select the channel you want to watch, on the TV.
Second Audio Recording
This VCR's built-in MTS decoder enables reception of
Multichannel TV Sound broadcast. To record a SAP program
received, set "2ND AUDIO RECORD" to "ON". Refer to "2ND
AUDIO RECORD – ON/OFF" in "Function Settings" section for
detail.
) on the VCR repeatedly until the
7
) on the Remote or STOP/EJECT
8

Timer Recording

Up to 8 timer recording programs can be made using Express
timer programing method as far as a year in advance. Remember,
the clock must be set before you can program the timer.
NOTES:
● If all the 8 programs have already been set, "PROGRAM FULL"
appears on the TV screen.
● After timer recording is completed, the VCR turns off
automatically.
● You can program the timer recording while a regular recording
is in progress; the menu screens will not be recorded.
● To timer-record cable or satellite channels, be sure to keep the
cable box or DBS receiver turned on with the correct channel
selected.

Express Timer Programing

Load a cassette with the record safety tab intact. The VCR turns
on, and the counter is reset, automatically.
A
Press PROG. on the Remote to access Program screen.
B
Press START+/–, STOP+/–, DATE+/–
or CH+/– repeatedly to enter the start
time, stop time, date or channel.
● Press and hold START+/– or
STOP+/– to increase the time in
30-minute intervals.
● To set the tape speed, press SP/EP.
● To timer-record daily (Monday–
Friday) or weekly serials, press DAILY (M-F) or WEEKLY.
Pressing the button again makes the "DAILY" or "WEEKLY"
display disappear.
C
Press OK or PROG..
● If "PROGRAM NOT COMPLETED PROGRAM OVERLAP"
appears, refer to "Program overlap warning display".
D
Press TIMER. The VCR turns off automatically and "
displayed on the display panel.
Timer programing will be lost after a power failure occurs.
NOTE:
If the tape reaches its end during timer recording, the recording
stops and "#", " " and " $" on the front display panel blink.
Press TIMER to disengage timer, then press STOP/EJECT ( 0 )
on the VCR to eject the tape or press REW ( 3 ) to rewind the
tape.
PROGRAM 1
START STOP
– –:– –AM – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
" is
#