Preparation; Installing The Battery - JVC KV-DV7J Instructions Manual

Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
• The remote signal reception lamp flashes when
the unit receives a remote control signal from the
remote controller.
DVD / VIDEO CD / CD
PHONES
DVD VCD/CD
Remote signal
reception lamp
• Do not expose the remote sensor to strong light
(direct sunlight or artificial lighting).
WARNING:
• Store the batteries in a place which children
cannot reach.
If a child accidentally swallows the batteries,
immediately consult a doctor.
• Do not recharge, short, disassemble or heat the
batteries or dispose of in a fire.
Doing any of these things may cause the
batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic
materials.
Doing this may cause the batteries to give off
heat, crack or start a fire.
• When throwing away or saving batteries, wrap in
tape and insulate; otherwise, it may cause the
batteries to give off heat, crack or start a fire.
• Do not poke the batteries with tweezers or
similar tools.
Doing this may cause the batteries to give off
heat, crack or start a fire.
OPEN
KV-DV7 DVD / CD PLAYER
Remote sensor

PREPARATION

Installing the battery

When the controllable range or effectiveness of the
remote controller decreases, replace the battery.
1
. Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball-point pen
or a similar tool.
2) Remove the battery holder.
(back side)
2
. Place the battery.
Slide the battery into the holder with the + side
facing upwards so that the battery is fixed in the
holder.
3
. Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
(back side)
1)
2)
Lithium coin battery
(product number:
CR2025)
5