Advertisement
Connecting the remote sensor unit
• When used with any other monitor system than KD-AV7001.
• Before installing, make sure the remote controller functions properly with the remote sensor
unit placed in your selected position.
• Wipe clean the selected area sufficiently, and affix the remote sensor unit to the place firmly
after removing the protective sheet from the double-faced adhesive tape.
• Avoid any area on the dashboard, etc. subjected to direct sunlight.
Select an area where the remote sensor unit can receive remote signals through its front face
(sensing area).
OPERATIONS
The following operations cannot be used when connecting this TV tuner
unit to KD-AV7001.
• When connecting to KD-AV7001, refer to the Instructions supplied with them.
3
1
4
2
5
1 Standby/On button
Press to turns on and off the TV tuner unit.
2 TV CH (channel) 5 / ∞ button
• Press to search for the TV channels ("SEARCH" appears). When a TV station is received,
search will stop.
• Press and hold to activate manual search ("MANUAL" appears) for the TV station. Then
press repeatedly to change the TV channels.
3 AUTO PRESET button
• Press to display the preset channel list.
• Press and hold to preset the receivable TV stations automatically into the preset number
buttons (1 – 12).
4 DISP (display) button
Press to display the preset channel number on the monitor.
5 Preset number buttons (1 – 12)
• Press to select the preset channel number directly.
• Press and hold to store a TV station into preset number (1 – 12).
SPECIFICATIONS
TV TUNER UNIT
TV antenna jack × 4
AV bus terminal × 1
Remote sensor jack × 1
Output
Video: RCA pin × 1; 1 V(p-p), 75 Ω
Audio: RCA pin × 2; 150 mV(rms)
Dimensions (W × H × D): 163 mm × 28 mm × 122 mm
Mass: 620 g
DIVERSITY ANTENNANA
Output impedance: 75 Ω × 4 (with mini plug)
Cord length: 5 m
Dimensions (approx.) (W × H × D): 440 mm × 490 mm × 18 mm (without the cable)
Mass (each unit) (approx.): 220 g (including the cable)
×
GENERAL
Channel coverage
VHF: ch 1 – 12
UHF: ch 21 – 69
Power requirement
Operating voltage: DC 14.4 V (11 V to 16 V allowance)
Grounding system: Negative ground
Allowable operating temperature: 0°C to +40°C
Design and specifications subject to change without notice.
Double-faced adhesive tape (supplied)
1
2
CR2025
•
Sensing area
•
•
•
•
DO NOT leave the remote controller in a place (such as
dashboards) exposed to direct sunlight for a long time.
Otherwise, it may be damaged.
3
1
5 ∞
2
•
•
3
•
•
4
5
•
•
×
×
×
×
×
×
×
×
×
Дизайн и технические характеристики могут быть изменены без уведомления.
4
Dashboard, etc.
×
Ω
×
Ω ×
×
×
Advertisement
