Loading A Cassette /Unloading A Cassette - JVC CU-VH1EXS Instructions Manual

Digital hd player
Table of Contents

Advertisement

16
EN
Loading A Cassette
/Unloading A Cassette
The player needs to be powered up to load or eject a
cassette
Cassette holder
cover
OPEN/EJECT
Switch
Cassette
holder
Make sure the
window side is
facing up.
Erase protection tab
1
Slide and hold OPEN/EJECT in the direction of
arrow, then pull the cassette holder cover open
until it locks. The cassette holder opens
automatically.
Do not touch internal components.
2
Insert or remove a tape and press "PUSH HERE"
to close the cassette holder.
Be sure to press only the section labeled
"PUSH HERE" to close the cassette holder;
touching other parts may cause your finger to
get caught in the cassette holder, resulting in
injury or product damage.
Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
When the battery pack's charge is low, you may
not be able to close the cassette holder cover.
Do not apply force. Replace the battery pack
with a fully charged one or use AC power
before continuing.
3
Close the cassette holder cover firmly until it
locks into place.
To protect valuable recordings...
Slide the erase protection tab on the back of the tape
in the direction of "SAVE". This prevents the tape
from being recorded over. To record on this tape,
slide the tab back to "REC" before loading it.
PUSH HERE
Approximate recording time
Tape
30 min.
30 min.
60 min.
60 min.
80 min.
80 min.
To switch the recording mode, refer to pages 28 and
29.
NOTES:
It takes a few seconds for the cassette holder to
open. Do not apply force.
If you wait a few seconds and the cassette holder
does not open, close the cassette holder cover and
try again. If the cassette holder still does not open,
turn the player off then on again.
If the tape does not load properly, open the
cassette holder cover fully and remove the
cassette. A few minutes later, insert it again.
When the player is suddenly moved from a cold
place to a warm environment, wait a short time
before opening the cassette holder cover.
Closing the cassette holder cover before the
cassette holder recedes may cause damage to the
player.
Even when the player is switched off, a cassette
can be loaded or unloaded. After the cassette
holder is closed with the player switched off,
however, it may not recede. It is recommended to
turn the power on before loading or unloading.
When resuming recording, once you open the
cassette holder cover a blank portion will be
recorded on the tape or a previously recorded
scene will be erased (recorded over) regardless of
whether the cassette holder came out or not. See
"Recording From The Middle Of A Tape"
(
pg. 36).
Recording mode
SP
LP
45 min.
90 min.
120 min.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cu-vh1usLyt1300-001aCu-vh1

Table of Contents