Tuning In To A Preset Station - JVC KS-FX811U Instructions Manual

Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the band changes
as follows:
FM1 FM2
(F1) (F2)
2
Tune in to a station (in this
example, of 88.3 MHz.)
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
Selected band/preset number and
"MEMO" (memory) appear
alternately for a while.
FM3 AM
(F3)
Press ¢
to tune
in to stations of higher
frequencies.
Press 4
to tune
in to stations of lower
frequencies.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on pages 8 and 9.
1
Select the band (FM1 – 3, AM).
FM1 FM2
(F1) (F2)
2
Select the number (1 – 6) for the preset
station you want.
Note:
You can also use the 5 (up) or ∞ (down) buttons on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or ∞ (down) buttons,
the next or previous preset station is tuned in.
FM3 AM
(F3)
9