Active Storage mRAID16 Quick Start Manual page 6

2b Installing storage systems into the cabinet
NOTICE
l Do not stack components. Install them on guide rails.
l If you remove controllers and disks to facilitate a move, record the location of each component and its slot in
advance to help when inserting each component back to its correct slot.
l If the controller is inserted into a different location, a system power-on failure may occur.
Installing mRAID16 and mRAID16 Expansion
Installing mVault75
(1) Install the inner rail.
(2) Mount the mVault75.
When mounting the mVault75, place the side step in the rear of the mVault75 on the front bracket of the ball
bearing guide rails, and slide the mVault75 in the cabinet along the ball bearing guide rails (no manual
alignment is required because the inner rail automatically connects to the middle rail).
Place the side step at
the rear of the system
to the front bracket of
the bear ball guide rail.
Slide the system
horizontally into the
cabinet (the inner rail
and middle rail will be
automatically pushed
into place).
Install mRAID16 Expansion on the guide rails
using the same method as installing the
mRAID16.
(3) Install a cover.
(4) Install the mVault75.