Editing; Tape Dubbing - JVC GR-SZ7000EG Instructions Manual

EDITING

To AUDIO
and VIDEO
connectors
A/V cable
(provided)
To AUDIO,
VIDEO and
-IN connectors
S
If your VCR has the
SCART connector,
use the provided
cable adapter.
VCR (Recording deck)

Tape Dubbing

1
PLAY/PAUSE
Power switch
2
3
4
To -VIDEO
S
connector
5
S-VIDEO cable
(provided)
6
7
NOTES:
"Y/C"/"CVBS"
video out
select switch
CONNECT EQUIPMENT
Following the illustration at left, connect the
camcorder and the VCR. (refer also to page 32 and
33)
PREPARE FOR DUBBING
Set the camcorder's Power switch to "PLAY", turn
on the VCR's power, and insert the appropriate
cassettes in the camcorder and the VCR.
SELECT VCR MODE
Engage the VCR's AUX and Record-Pause modes.
FIND EDIT-IN POINT
Engage the camcorder's Play mode to find a spot
just before the edit-in point. Once it's reached, press
PAUSE on the camcorder.
START EDITING
Press PLAY on the camcorder and engage the VCR's
Record mode.
STOP EDITING TEMPORARILY
Engage the VCR's Record-Pause mode and press
PAUSE on the camcorder.
EDIT MORE SEGMENTS
Repeat steps 4 through 6 for additional editing, then
stop the VCR and camcorder when finished.
If your VCR has an S-VIDEO input connector or a
SCART connector compatible with Y/C signals, connect
the camcorder and the VCR using the provided S-
VIDEO cable. This can improve the dubbed picture
quality.
If you use the provided cable adapter, set the "Y/C"/
"CVBS" video out select switch as required.
Y/C : When connecting to a VCR which accepts Y/C
signals and uses an S-VIDEO cable.
CVBS : When connecting to a VCR which does not
accept Y/C signals and uses an audio/video
cable.
37
EN