CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
CONNECT CAMCORDER TO TV OR
Pull out the connector cover and open it.
Connect as shown in the illustration (
If using a VCR . . . go to step 3.
If not . . . go to step 4.
CONNECT VCR OUTPUT TO TV
Refer to your VCR's instruction manual.
Turn on the camcorder, the VCR and the TV.
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder's Power Switch to "CAMERA" ("AUTO"
or "PRO."), then set your TV to the appropriate
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
Following the illustration on pg. 38, connect the
camcorder and the VCR.
PREPARE FOR DUBBING
Set the camcorder's Power Switch to "PLAY",
turn on the VCR's power, and insert the
appropriate cassettes in the camcorder and the
SELECT VCR MODE
Engage the VCR's AUX and Record-Pause
FIND EDIT-IN POINT
Engage the camcorder's Play mode to find a spot
just before the edit-in point. Once it is reached,
press PLAY/PAUSE (4/6) on the camcorder.
Press PLAY/PAUSE (4/6) on the camcorder and
engage the VCR's Record mode.
STOP EDITING TEMPORARILY
Engage the VCR's Record-Pause mode and press
PLAY/PAUSE (4/6) on the camcorder.
EDIT MORE SEGMENTS
Repeat steps 4 through 6 for additional editing,
then stop the VCR and camcorder when