JBL VENUE SUB12 Owner's Manual
  1. Manuals
  2. Brands
  3. JBL Manuals
  4. Subwoofer
  5. Venue SUB12
  6. Owner's manual

JBL VENUE SUB12 Owner's Manual

120v
Hide thumbs Also See for VENUE SUB12:

Advertisement

Table of Contents

See also: Service Manual
®
™
JBL VENUE
SUB12 (120V)
OWNER'S GUIDE

Advertisement

Table of Contents
loading

Related Manuals for JBL VENUE SUB12

Summary of Contents for JBL VENUE SUB12

  • Page 1 ® ™ JBL VENUE SUB12 (120V) OWNER’S GUIDE...

  • Page 2: Read First

    READ FIRST! Important Safety Precautions! CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. CAUTION: To prevent electric shock, do not use this (polarized) plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to...

  • Page 3: Unpacking The Subwoofer

    INTRODUCTION ® SUB12 Powered Subwoofer For more than 60 years, JBL has been providing audio equipment to concert halls, recording studios and movie theaters around the world, and has become the hands-down choice of leading recording artists and sound engineers.

  • Page 4: Rear Panel

    For LFE use L or R HIGH § LEVEL + – ¶ POWER JBL Venue SUB12 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

  • Page 5: System Connections

    L or R input. POWER If your receiver/processor does not have subwoofer outputs for the left and right channels or an LFE output, connect speaker wire from your receiver/amplifier to your speakers...

  • Page 6: Crossover Adjustment

    If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your subwoofer ever needs service, contact your local JBL dealer or visit www.jbl.com for a service center near you.

  • Page 7: Specifications

    SPECIFICATIONS Frequency Response Amplifier RMS Power Amplifier Peak Dynamic Power Crossover Frequency Driver Dimensions (H x W x D) (with grille) Weight † The Peak Dynamic Power is measured by recording the highest center-to-peak voltage measured across the output of a resistive load equal to minimum impedance of the trans- ducer, using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
  • Page 8 All features and specifications are subject to change without notice. JBL and Harman International are registered trademarks, and Venue Series, EOS, PolyPlas and Pro Sound Comes Home are trademarks, of Harman International Industries, Incorporated. Dolby and Pro Logic are registered trademarks of Dolby Laboratories.

Table of Contents