Page 1
– and that when you think about purchasing additional audio equip- ment for your home, car, or office you will once again choose JBL. Please take a moment to complete the enclosed profile card. It...
AS Series Owner’s Manual 9/11/98 12:51 PM Page 2 one. Speaker Placement AS5, AS6, AS8 as front speakers AS5, AS6, AS8 as rear speakers 5 – 6 ft. AS65C in ceiling AS SUB...
The wires for both speakers should be the same length. If one speaker is placed closer to the amplifier than the other, hide the excess wire behind the wall. AS5, AS6, AS8, AS65C LEFT – – + – + LEFT...
However, if you or a qualified installer. are unsure of your ability to Tools Needed Phillips #2 screwdriver Measuring tape Pencil Carpenter’s level AS5, AS6, AS8 Installation Kit Template Speaker frame Retainer clips Four mounting brackets Page 4 Utility knife...
Step Four: Step Five: Cut the dry wall. Place the mounting bracket on the speaker frame using the mounting guides (marked 3/8" , 1/2" , 5/8" , and 3/4") corre- sponding to the thickness of the dry wall. Step Seven:...
1-1/2" Step Three: Attach the proper mounting brackets, marked and preset at 3/8" , 1/2" , 5/8" , and 3/4" , corre- sponding to the thickness of the dry wall, to the speaker frame. Step Seven: Replace the metal grille.
Page 7
Determine the correct subwoofer frame. subwoofer location. Step Four: Step Five: Loosen the eight phillips head Connect the speaker wires to screws until the locking tabs the baffle assembly. turn inward. Step Seven: Step Eight: Screw down each of the eight Replace the metal grille.
Page 8
Remove the grille from the Determine the correct speaker speaker frame. location. Step Four: Step Five: Connect the speaker wires to Loosen the three phillips head the speaker. screws on the frame until the locking tabs turn inward. Step Seven:...
Page 9
AS Series Owner’s Manual 9/11/98 12:51 PM Painting the Speaker Frame and Grille AS Series loudspeakers can be This will protect the speaker painted to match any style of components and baffle from decor. If you wish to change paint residue.
Make sure all wires and speakers. Make sure all wires are connected. Make sure none are connected. Make sure none of the speaker wires are frayed, of the speaker wires are frayed, cut, or punctured. cut, or punctured.
AS Series Owner’s Manual 9/11/98 12:51 PM Specifications SYSTEM Frequency Response (–6dB): 50Hz – 20kHz Recommended Maximum Amplifier Power*: 40 watts Sensitivity: 88dB Impedance: 8 ohms nominal Crossover Frequency: 6kHz Woofer: 5-1/4" Tweeter: 1" titanium Outside Dimensions (HxWxD**): 11 x 7-1/2 x 2-5/8" 280 x 190 x 67mm SYSTEM Frequency Response (–6dB):...