Summary of Contents for J-TECH Solar Auxiliary Power Unit
Page 1
Solar Auxiliary Power Unit Remote Meter Operator’s Guide Customer Service: service@jtechusa.com (610) 458-4334 45 Senn Drive Chester Springs, PA 19425 (Scan for latest version of this guide.) P/N SolarAPUOG Updated August 11, 2022...
Page 2
METER MENU ........1 System information for your J-Tech Solar Auxiliary Power Unit BUTTONS .
Page 3
GETTING TO KNOW YOUR SOLAR APU GETTING TO KNOW YOUR SOLAR APU BUTTONS Units Indicators – Displays the units of the numerical The Solar APU meter has three (3) buttons for meter menu information. Units may be used in combination if necessary ( e.g., navigation as shown in Figure 2.
Page 4
OPERATION OPERATION METER OPTIONS MENU button turns on the backlight. The backlight timer specifies how The Meter Options Menu is used to adjust temperature units, long the backlight shall remain on after the last button press. backlight timing, and the meter menu navigation. To access the Off —...
Page 5
OPERATION TROUBLESHOOTING GUIDE simultaneously and can be reset at any time, from any screen in CONDITION POSSIBLE CAUSE CORRECTION the menu. There is no The meter is Verify that CLEANING THE METER display. not powered. the controller or inverter Cleaning the LCD Window – Disconnect the meter cable and connected to remove the three Phillips screws that secure the meter back the Solar APU...
Page 6
TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE The LCD display is 1. System battery 1. Check the Dust or debris has Meter has collected Follow the dim. voltage is low. system battery collected in the dust or debris. instructions for voltage. Low LCD window. cleaning the meter battery voltage LCD found in...
Need help?
Do you have a question about the Solar Auxiliary Power Unit and is the answer not in the manual?
Questions and answers