Download Print this page

Iceking FF218WE Installation And Operating Manual page 12

F rated top mount fridge freezer in white

Advertisement

Section 2. Safety Advice
Please read this booklet thoroughly before installing and switching on
-
the appliance. The manufacturer accepts no responsibility for incorrect
installation and usage.
If this appliance is to replace an old refrigerator with a lock, as a safety
-
measure break or remove the lock and/or door before disposal.
Your old appliances contain insulation gases and refrigerant that must
-
be disposed of correctly. Please ensure that the refrigerant circuit is not
damaged before the appliance is taken away for correct disposal in line
with current legislation. If there is any doubt contact your Local
Authority for instructions.
This appliance may contain the refrigerant isobutene (R600a). This is a
-
natural gas with a high level of environmental compatibility; however,
caution is required as isobutene is a flammable gas. It is essential to
ensure that refrigerant tubes are not damaged during transportation and
the installation of the appliance. In the event that the refrigerant circuit is
damaged, avoid naked flames or sources of ignition and ventilate the room
in which the appliance is situated.
Do not damage the refrigerant circuit.
-
The appliance is not intended for use by persons (including children)
-
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do
not play with the appliance.
If using an adaptor, this must be used in accordance with the
-
manufacturers instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.
Do not twist or bend the cables, and keep them away from hot surfaces.
-
Do not plug ın or unplug this appliance with wet hands.
-
Following installation make sure that the power cable is not trapped
-
underneath the appliance.
If the power supply cord is damaged, it must be replaced by the
-
manufacturer, it's service agent or similarly qualified persons in order to
avoid a hazard.
9

Advertisement

loading