Maintenance - Black & Decker ST7700-CA Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

English

MAINTENANCE


WARNING:
injury, unplug the appliance before performing
any maintenance.
Keep the air intake slots clean to avoid overheating.
Your trimmer line can dry out over time. To keep your line
in top condition, store spare pre-wound spools or bulk line
in a plastic, sealable bag with a tablespoon of water.
Plastic parts may be cleaned by using a mild soap and a
damp rag.
The line cutter on the edge of the guard can dull over
time. It is recommended you periodically touch-up the
sharpness of the blade with a file.
iMPOrTanT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed
by authorized service centers or other qualified service
organizations, always using identical replacement parts.
AUTOMATIC LINE FEED DOES NOT WORK
Unplug the trimmer.
Remove the spool cap.
Make sure you are using 0.065 inch (1.65 mm) diameter
ROUND line.
Check to see if the lever is in place and pivots freely.
Pull the cutting line until it protrudes approximately 5-3/8
inches (136mm) from the spool. If insufficient cutting line
is left on the spool, install a new spool of cutting line.
Ensure that the line is not crisscrossed on the spool as
detailed in figure T. If it is, unwind the cutting line, then wind
it back on the spool neatly so that the lines do not cross.
Ensure the beginning of the cutting line is pulled tight
against the spool as shown in figure S.
Align the tabs on the spool cap with the cut outs in
the housing.
Push the spool cap onto the housing until it snaps securely
into place.
If the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade. If the automatic
line feed still does not work or the spool is jammed, try the
following suggestions:
-
Carefully clean the spool and housing.
-
Remove the spool and check if the lever in the spool
housing can move freely.
-
Remove the spool and unwind the cutting line, then wind
it on neatly again. Replace the spool into the housing.
8
To avoid serious
Two-Year Limited Warranty
Black & Decker (U.S.) Inc. warranties this product to be free from defects in
material or workmanship for a period of two (2) years following the date of
purchase, provided that the product is used in a home environment. This
limited warranty does not cover failures due to abuse, accidental damage
or when repairs have been made or attempted by anyone other than
BLACK+DECKER and its Authorized Service Centers. A defective product
meeting the warranty conditions set forth herein will be replaced or repaired
at no charge in either of two ways: The first, which will result in exchanges
only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer).Returns should be made
within the time period of the retailer's policy for exchanges. Proof of purchase
may be required. Please check with the retailer for its specific return policy
regarding time limits for returns or exchanges. The second option is to take
or send the product (prepaid) to a BLACK+DECKER owned or authorized
Service Center for repair or replacement at BLACK+DECKER's option. Proof of
purchase may be required. BLACK+DECKER owned and authorized service
centers are listed online at www.blackanddecker.com. This warranty
does not apply to accessories. This warranty gives you specific legal rights and
you may have other rights which vary from state to state. Should you have
any questions, contact the manager of your nearest BLACK+DECKER Service
Center. This product is not intended for commercial use, and accordingly, such
commercial use of this product will void this warranty. All other guarantees,
express or implied, are hereby disclaimed.
FREE WARNING LABEL REPLACEMENT: If your
warning labels become illegible or are missing, call 1-800-
544-6986 for a free replacement.
LATIN AMERICA: This warranty does not apply to products sold in Latin
America. For products sold in Latin America, check country specific warranty
information contained in the packaging, call the local company or see the website
for such information.
Accessories

WARNING:
those offered by BLACK+DECKER have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BLACK+DECKER, call
1-800-544-6986.
Since accessories, other than

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

St7700

Table of Contents