Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pentair HYDROMATIC HTS33A1
Summary of Contents for Pentair HYDROMATIC HTS33A1
- Page 1 Pump Installation and Service Manual HTS33A1 Submersible High Temperature Sump Pump NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
- Page 2 2. Risk of Electrical Shock: and feet away from impeller when General Connect only to a properly power is connected. Information grounded receptacle. DO NOT use in swimming pools, Septic tank is to be vented decorative fountains or any in accordance with local installation where human contact Thank you for purchasing your plumbing codes.
- Page 3 hole in the impeller chamber to let motor windings, are available in The dosing tank or pumping out trapped air. If this hole volts with overload chamber must be constructed of becomes plugged, pump may air protection, and use a double corrosion-resistant materials and lock.
- Page 4 the discharge line to relieve power cord. Do not just turn off Pump air lock. circuit breaker or unscrew fuse. Servicing b. Check valve may be installed backward. Check flow arrow Use only repair parts called out on valve body. Check shut- in parts list supplied in these Read the following instructions off valve.
- Page 5 All pump repairs should be done tool (a piece of PVC pipe stationary seal face. Center at an authorized Hydromatic works well), push on the the seal on the shaft. service center. rubber portion of the stationary 8. Place the impeller onto the seal until it is evenly seated shaft.
- Page 6 wrench until snug, but do not new O-ring into position. Pump overtighten. Be careful not to cut O-ring Servicing when installing. 5. Plug pump into grounded receptacle to test operation. 4. Position new motor housing Pump must run quiet, free (with new stator) onto the pump tighten.
- Page 7 HTS33A1 Parts List 1" (204) 21" (144) 11" (280) PUMP ON 5" PUMP OFF 3" 3" (315) (289) 1" 13" (180) (122) 2" 1" (50) Winding Locked Resistance Max. Rotor Speed Volts Phase In OHMS Amps. Amps 1550 16.0 ( ): Dimensions in mm Ref.
- Page 8 LIMITED WARRANTY HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2"), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.
Need help?
Do you have a question about the HYDROMATIC HTS33A1 and is the answer not in the manual?
Questions and answers