Table of Contents
Advertisement
Quick Links
FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
connected.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC RF exposure statements
This Transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator
and your body or nearby persons.
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
WARNING!
Requires Speed Class 6 or higher microSD or
CHOKING HAZARD - Small parts.
microSDHC card(not included)
Not suitable for children under 3 years.
microSDHC Logo is a trademark of SD-3C, LLC.
Conforms to safety requirements of FCC.
Voyage Aeronuatics™ is the registered trademark of AMAX Industrial Group LTD.
AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024
© 2020 All Rights Reserved. Visit us at www.amaxbrands.com
17
HD STREAMING VIDEO DRONE
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect the battery from charger immediately after the battery
is fully charged. Please refer to enclosed safety instructions.
PA-1003
2.4G Wireless
Controller
Made in China
C001-CA-V1.0
PA-1003
ON BOARD
HD CAMERA
1280 x 720 pixel
25 frames per second
INSTRUCTION BOOKLET
PACKAGE CONTAINS:
Phone Holder
Spare Parts
USB Charger
Battery
Colors and styles may vary slightly .
ON BOARD
HD VIDEO
Instruction
Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Amax PA-1003
Summary of Contents for Amax PA-1003
- Page 1 Conforms to safety requirements of FCC. Voyage Aeronuatics™ is the registered trademark of AMAX Industrial Group LTD. AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024 © 2020 All Rights Reserved. Visit us at www.amaxbrands.com PA-1003 Phone Holder 2.4G Wireless...
-
Page 2: Table Of Contents
Recognizing The Front & Rear Of The PA-1003 ....... 5... -
Page 3: Pa-1003 Diagram
PA-1003. Make sure that there are no other 2.4G devices in the area. 2. Insert the battery into the PA-1003 and set it down on a flat level surface. Press down the power button and hold for a few seconds (see diagram F).The LED lights on the drone should begin to flash. -
Page 4: Now You Are Ready To Fly
Below is a list of basic flight functions for your long-range remote to control the PA-1003. While learning to fly your PA-1003 it is best to start in a large space with the drone facing away from you until you get used to the basic controls. -
Page 5: Adjusting The Trim
1. Place the PA-1003 on a flat level surface Forward/Backward Trim 2. Make sure the PA-1003 is on and that the controller is synced (refer to syncing pg 4). Do not start the PA-1003 is moving forwards or backwards blades. Instead move both the throttles and control stick down and to the right corner (see diagram R). -
Page 6: Pa-1003 Wifi App Installation
3. For Apple® iOS devices, within the App Store, search and select “ voyage1003 ” . Hit the Install button and 2. This App also allows you to control your PA-1003 by your mobile device. To activate the control sticks, tap the “voyage1003”... -
Page 7: Troubleshooting Your Pa-1003
Crash landing at high-speed may cause damage to your PA-1003’s propellers. 1. The PA-1003 has four sets blades, two sets blades with indication number A & B on front, and two sets blades with indication number B & A on the rear (see the diagram V). -
Page 8: Warnings
Stand away from the PA-1003 to reduce the risk of getting into the flight path. Warn spectators that you will be flying your PA-1003 so that they are aware of its position. Before flight, inspect the rotor blades to make certain that the blades are securely fastened to the PA-1003. - Page 9 “clicking sound” . The microSD card will “pop-out” slightly and is ready for removal. videos for family and friends. Simply grab and pull gently away from the PA-1003’ s camera port to remove the card. Always store your microSD card in a clean, safe and cool environment.
Need help?
Do you have a question about the PA-1003 and is the answer not in the manual?
Questions and answers