Installation Instructions - Frigidaire EFMIS2438 Use & Care Manual

Beverage cooler - curved door
Table of Contents

Advertisement

Available languages

Available languages

Before Using Your Product
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
Model EFMIS2438 : (1)3 x Flat rack
Installation of Your Product
This Product is designed to be free standing installation only, and should
not be recessed or built-in (Fully recessed).
Place your Beverage Cooler on a surface that isstrong enough to support it when
it is fully loaded. Allow 5 inches of space between the back and sides of the
beverage cooler, which allows the proper air circulation to cool the heat sink.
Locate the Beverage Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly. This Beverage Cooler uses
thermoelectric refrigeration technology (no compressor) and is not designed for
storage in hot areas like garages, warehouses or outdoors since it is designed to
operate at a maximum of30 degrees below the ambient temperature.Avoid locating
the unit in moist areas.
Plug the adapter of Beverage Cooler into an exclusive, properly installed-grounded
wall outlet.Do not under any circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power and/or grounding should be
directed toward a certied electrician or an authorized Products service center.
After plugging the adapter of Beverage Cooler into a wall outlet, allow the unit to
cool down for 2-3 hours before placing any items in the compartment.

INSTALLATION INSTRUCTIONS

(2) 1 x Defender
(3) Instruction Manual x l

Advertisement

Table of Contents
loading

Table of Contents