Special Instructions - Intermatic ET70415CR User Manual

SPECIAL INSTRUCTIONS

Enclosure Mounting The top mounting hole on the enclosure
bracket is slotted; it is not necessary to remove the power module
unless you want to change the input voltage. If the change is
required to meet your available voltage, remove the power module
before mounting the enclosure. Mount the enclosure with #8 or
10 pan head or #6 or 8 hex head screws. The cover can be
removed by lifting upward off hinges for convenience in
installation.
WARNING: Disconnect all power at the service panel before
removing the logic module.
Removing Logic Module (required for wiring). Pull the
retaining tab to the left and lift logic module away on the left side.
STOP: Disconnect cable from rear of logic module by pulling
straight back on the cable.
Opening the Logic Module
To remove the metal logic module
cover, remove the screws on the
back and lift off, exposing the circuit
board. Reverse steps to replace cover.
The following three procedures
require cover removal.
Converting to 24 Hour
Display Mode The time switch is
shipped with 12 hr. AM/PM
timekeeping; 24 hr. is available by
removing the jumper from the pin
connector on the circuit board. The jumper(s) may be stored for
later use by reinstalling on the outer pins only.
Daylight Saving Time Override Override the automatic
DST adjustment (in Arizona, Hawaii and parts of Indiana) by
removing the jumper on the circuit board.
26
Swing Up
SUN MON TUE WED THU
1 2 3 4 5
FRI SAT DY ND ALL
WK WK
6 7 8 9 0
AM PM PULSE INTVL ASTRO
Pull
PROG REV SET UP HLDY
OK CLEAR COPY HELP
ON/OFF ON/OFF ON/OFF ON/OFF
SPECIAL INSTRUCTIONS
Battery Replacement The 8 yr. lithium battery is located on
the back of the circuit board under the metal battery terminal
clips. Replace with Panasonic or Rayovac BR2325 (or equivalent).
Re-installing Logic Module Carefully plug the 10 wire cable
straight into the connector on the rear of the logic module. The
sawtooth shape on both connectors must line up to allow the cable
connector to be seated. Engage the cut-aways on the right side of
the logic module with the guides in the plastic terminal block and
snap the left hand side in place. It may be necessary to use a small
screwdriver to push the left hand retaining tab slightly to the left
to allow the module to snap in place.
Removing Power Module
(required to change input
voltage or to access rear
power input terminals on 24
volt model) Remove the logic
module. Remove the (3) screws that
secure the power module to the
enclosure. Use the logic board
retaining tab to lift the power
module out of the enclosure.
Power Module
Ground Wire
Installed In
Connect To Case
Enclosure
Ground Below
POWER MODULE
(front view)
Next Generation
27