Table of Contents
Advertisement
On-board failure logging (OBFL) to collect information about the switch and the power supplies
connected to it.
Enhanced object tracking (EOT) for HSRP to determine the proportion of hosts in a LAN by
tracking the routing table state or to trigger the standby router failover.
IP Service Level Agreements (IP SLAs) support to measure network performance by using active
traffic monitoring (IP services feature set is required).
IEEE standards
The Cisco Catalyst Switch Modules 3110G and 3110X support the following IEEE standards:
IEEE 802.1d Spanning Tree Protocol (STP)
IEEE 802.1s Multiple STP (MSTP)
IEEE 802.1w Rapid STP (RSTP)
IEEE 802.1p CoS prioritization
IEEE 802.1Q Tagged VLAN (frame tagging on all ports when VLANs are enabled)
IEEE 802.1x port-based authentication
IEEE 802.2 Logical Link Control
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit Ethernet
IEEE 802.3z 1000BASE-X
IEEE 802.3ad Link Aggregation Control Protocol
IEEE 802.3x Full-duplex Flow Control on all ports
IEEE 802.3ae 10GBASE-SR 10 Gb Ethernet (3110X only)
Cisco Catalyst Switch Modules 3110G and 3110X for IBM BladeCenter
9
Advertisement
Table of Contents
