Swine Robotics Boar Bot Owner's Manual page 29

4. If the two speed Boar Bot does work in Lo speed but not in Hi speed, then the
receiver and solenoids are working.
A. Check if the switching solenoids are clicking.
B. Check the Hi/Lo switch.
C. Check the rear battery, associate wiring and terminals.
5. Default relay failure will cause the following symptoms.
A. The Boar Bot will not operate in Hi speed.
B. The Boar Bot will not default to Lo speed in reverse operation.
6. Default isolation diodes failure will cause the following symptoms.
A. The Boar Bot will not default to Lo speed in reverse operation.
B. Right or left reverse will result in all wheels in reverse.
7. Switching solenoid failure of either solenoid or both solenoids will result in no
Hi speed operation.
8. Circuit breaker failure of either circuit breaker has occurred if the Boar Bot
while operating properly begins a gradual slow down and finally comes to a stop. If the
Boar Bot is switched off and then switched on again, the movement of the Boar Bot will
repeat the gradual slow down. Replace the bad circuit breaker or breakers.
25
22