Figure 4-3: Check For Compatibility Screen; Figure 4-4: Disconnect The Power From The Phone Adapter Or Ip Phone Screen - Cisco WIRELESS-G WBP54G User Manual

Wireless-G Bridge for Phone Adapters
3. This screen will inform you about which Linksys phone adapters and IP phones work with the Bridge. Make
sure your phone adapter or IP phone is listed on-screen. Click Next to proceed with the installation process,
or click Back to return to the previous screen. To exit the Setup Wizard, click Exit.
NOTE: The power adapter for your Linksys phone adapter or IP phone will be used to
power the Bridge.
4. You will use the PC running this Setup Wizard to set up the Bridge. Disconnect the power jack from the back
of the Linksys phone adapter or IP phone. (You will use this power adapter to power the Bridge.) If your
network router or this PC is in a different room, disconnect the power adapter from the electrical outlet. Move
the power adapter and Bridge to the room where your router or PC is located.
Click Next to proceed, or click Back to return to the previous screen.
Chapter 4: Setting Up and Connecting the Wireless-G Bridge for Phone Adapters
Running the Setup Wizard

Figure 4-3: Check for Compatibility Screen

Figure 4-4: Disconnect the Power from the Phone
Adapter or IP Phone Screen
8