Equipment That You Supply; Before You Begin - Cisco IE 3000 Getting Started Manual

Equipment That You Supply

Before You Begin

Cisco IE 3000 Switch Getting Started Guide
12
Attaching the Power and Relay Connector, page 20
•
Optional Procedures, page 21
•
Obtain these necessary tools and equipment:
Ratcheting torque flathead screwdriver that exerts up to 15-inch pound (in-lb)
•
of pressure
Ring terminal lug (such as Thomas & Bett part number 10RC6 or equivalent)
•
Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001, or
•
equivalent)
10- to 12-gauge copper ground wire (such as Belden part number 9912 or
•
equivalent)
For DC power connections, use UL- and CSA-rated style 1007 or 1569
•
twisted-pair copper appliance wiring material (AWM) wire (such as Belden
part number 9318)
Wire-stripping tools for stripping 10-, 12-, and 18-gauge wires
•
For rack-mounting, a number-2 Phillips screwdriver
•
A flat-blade screwdriver
•
When you determine where to install the switch, verify that these guidelines
are met:
Operating environment is within the range in the switch hardware installation
•
guide.
Clearance to front and rear panels meets these conditions:
•
Front-panel LEDs can be easily read.
–
Access to ports is sufficient for unrestricted cabling.
–
Front-panel direct current (DC) power and relay connector is within
–
reach of the connection to the DC power source.
Cisco IE 3000 Switch Getting Started Guide
OL-16234-01