Index Model references ..........................04 Specific instructions ........................04 Before using the fountain ......................05 Commissioning & Safe Usage....................06 Installation ............................... 07 Connections ......................... 07 Water temperature control ..................... 08 Maintenance ............................09 Problems ..............................10 Specifications............................11 Packaging and recycling ......................12...
The drinking fountain model and the serial number are indicated on the characteristics label, placed on the side of the fountain. WFT6 Free standing drinking fountain operated by push button. Stainless steel exterior, interior steel with anti corrosion treatment. With cup/bottle filler.
WARNING: To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. WARNING: When positioning the appliance, ensure the supply cord in not trapped or damaged WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
Water Regulations require that the mains connection point includes a non return valve with isolating tap, to avoid back flushing of water from the fountain into the mains Connect the supplied waste trap to a waste outlet Leave a 50cm gap all around the fountain to provide good ventilation ...
Do not install the cooler in places where the water can enter horizontally towards the cooling unit or below it.(for example near sprinklers or irrigation systems) Separate the water cooler at least 5-10 cm from the wall. We recommend using copper pipes when connecting to the mains water. LDPE food grade 1/4"...
It is recommended that all water connections are checked as part of the regular routine maintenance Water temperature control on WFT6 and WFP9T The digital thermostat is at the back of the Fountain. The temperature shown on the screen is the approximate temperature at the water outlet.
Maintenance Empty the internal water tank. Close the water inlet valve. Unplug from power supply. 2. Disconnect the drinking fountain from the water inlet allowing the water to come out. Push the button/pedal/tap or operate the sensor until the water stops to flow.
3. Sanitising should be in accordance with the WHA (Water Dispenser & Hydration Association, https://twha.co.uk) guidelines Drinking fountains out of order If the drinking fountain has been unplugged from the electric supply during many days (e.g. during holidays) it is recommended to empty the internal tank as described in previous section, removing the existing water which could has been corrupted due to the lack of cold.
Noise and vibration The cooler stands on an uneven surface Leaking Check water connection from the mains Check for internal leaks due to burst connection Specifications Water Fountains are not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or a lack of experience and knowledge.
Packaging and recycling Information to protect the environment. All packing materials are recyclable. Plastic bags and packaging materials should be keep away from children. The cooler does not contain CFCs gas, the refrigerant gas does not damage the ozone layer. The cooler has been labeled according to European WEEE Directive 2002/96/EC on Waste Electrical and Electronic Equipment which was replaced by Directive 2003/108/CE.
Page 14
Distributed by:: Cedar House Grange Farm Long Lane Newbury RG14 2TF TEL: 44 (0) 1635 202489 FAX: 44 (0) 1635 202499 E-mail: enquiries@aafirst.co.uk Web: http://www.aafirst.co.u...
Need help?
Do you have a question about the WFT6 and is the answer not in the manual?
Questions and answers