Removing Sfp Modules From Sfp Module Slots - Cisco 3750 Installation Manuallines

Chapter 3 Switch Installation

Removing SFP Modules from SFP Module Slots

Step 1
Step 2
Tip
Step 3
Step 4
Figure 3-37 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
1 3
1 4
1 5
1 6
1 7
1 8
1 9
13 X
2 0
14 X
1
Bale clasp
78-15136-01
To remove an SFP module from a module receptacle, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
the chassis.
Disconnect the LC from the SFP module.
For reattachment, note which cable connector plug is send (TX) and which is
receive (RX).
Insert a dust plug into the optical ports of the SFP module to keep the optical
interfaces clean.
Unlock and remove the SFP module, as shown in
If the module has a bale-clasp latch, pull the bale out and down to eject the
module. If the bale-clasp latch is obstructed and you cannot use your index finger
to open it, use a small, flat-blade screwdriver or other long, narrow instrument to
open the bale-clasp latch.
2 1
2 2
C a t a ly s t
2 3
2 4
3 7 5 0
23 X
1
24 X
1
S E R IE S
2
Catalyst 3750 Switch Hardware Installation Guide
Installing and Removing SFP Modules
Figure 3-37.
3-41