Table Or Shelf Mounting - Cisco 3750 Installation Manuallines

Installing the Switch

Table or Shelf Mounting

Step 1
Step 2
Catalyst 3750 Switch Hardware Installation Guide
3-34
Power on the switch. See the
•
page 1-6. If the switches are stacked, see the
section on page 3-12.
• Run the setup program. See the
page 1-8.
Connect to the front-panel ports. See the
•
10/100/1000 Ports" section on page 3-42
Module" section on page 3-44
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference. To use CMS, go to the
Your Browser" section on page
Follow these steps to install the switch on a table or shelf:
Locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach
the four rubber feet to the recessed areas on the bottom of the unit.
Place the switch on the table or shelf near an AC power source.
After the switch is mounted on the table, you might need to perform these tasks
to complete the installation, run the setup program, and access the switch:
(Optional) Connect the switches in the stacks. See the
•
StackWise Cable to the StackWise Ports" section on page
Connect to the console port and start the emulation software. See the
•
"Connecting to the Console Port" section on page 1-4
Terminal Emulation Software" section on page
• Power on the switch. See the
page 1-6. If the switches are stacked, see the
section on page 3-12.
Run the setup program. See the
•
page 1-8.
"Connecting to a Power Source" section on
"Powering Considerations"
"Completing the Setup Program" section on
"Connecting to the 10/100 and
and the
to complete the installation.
"Accessing the Switch from
1-13.
1-6.
"Connecting to a Power Source" section on
"Powering Considerations"
"Completing the Setup Program" section on
Chapter 3 Switch Installation
"Connecting to a SFP
"Connecting the
3-35.
and the "Starting the
78-15136-01