IBM Ultrastar 18XP Quick Installation Manual

IBM storage products

Quick installation guide

Ultrastar 9LP & 18XP
Multi-mode SE/LVD
Models: DGHS-09V, DGHS-09D,
DGHS-18V, DGHS-18D
Handling precautions
1. Do not cover the breather hole! Covering the
breather hole may result in loss of data.
2. Do not press on the drive! Do not apply any force
to the drive during handling or installation.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic dis-
charge (ESD).
4. Do not open the static-protective bag containing the
drive until required. Static electricity can damage the
drive.
5. Turn off and unplug your computer. Remove the
cover.
6. When installing the drive, touch a grounded,
unpainted metal surface with the static-protective
package containing the drive for at least two seconds.
(This drains static electricity from the package and
from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save the drive packaging material including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging.
IBM Hard Disk Drive Technical Support Center
Quick installation procedure
Note: It is advisable to backup all data before pro-
ceeding with the installation.
This procedure may require use of a bootable System
Diskette containing FDISK.COM and FORMAT.COM.
Setting the address
1. Each drive on the SCSI bus must have a unique
address. Sixty-eight and eighty-pin (Wide SCSI)
devices have 16 possible addresses.
2. SCSI address bits 3 (68- & 80-pin models only), 2,
1, and 0 of the 32-pin Option Jumper Block are used
to select the SCSI device ID.
SCSI Pin 1
Reserved
Auto
Start
Bl a nk
G N D
SCSI Address Bi t
3 2 1 0
1 3 5 7 11 13
2 4 6 8 10 12 14
G N D
Reserved
Reserved
Reserved
Page 1
Power Pin 1
Aux Connector Pin 1
::::::
Pin 35 Pin 2
External
Activity LED
Di s abl e Sync
Autostart
Negotiations
Write
Del a y
Protect
Force Si n gl e
Disable Unit
Ended Mode
Attention
Disable Wide Negotiations
15 17 19 21 23 25 27 29 31
1
16 18 20 22 24 26 28 30 32
Termi n ati o n
Power Enabl e
G N D
+5V
Di s abl e SCSI
Parity
2
version 2.0