Related Manuals for Timotion TDH8P
Summary of Contents for Timotion TDH8P
- Page 1 Hand Control Programming-TDH8P 20210811 User Manual Hand Control Programming- TDH8P Version 3 August 2021 1 of 11...
-
Page 2: Table Of Contents
Hand Control Programming-TDH8P Contents Contents ..................................2 Disclaimer .................................. 3 1. User Interface Guide ............................. 4 2. Reset ..................................5 3. Adjusting the Height ............................. 6 4. Setting the Memorized Position ........................... 6 5. Setting the Upper and Lower Height Limit ......................7 6. -
Page 3: Disclaimer
Hand Control Programming-TDH8P Disclaimer This user manual is ONLY for generic TiMOTION products. Manufacturers may have altered product settings causing them to differ from this user manual. Please contact the manufacturer for a revised manual if the product settings are different than this manual. -
Page 4: User Interface Guide
Hand Control Programming-TDH8P 1. User Interface Guide Up and down buttons Up and down buttons Memory setting buttons Memory setting buttons 3-digit height display Version 3 August 2021 4 of 11... -
Page 5: Reset
Hand Control Programming-TDH8P 2. Reset Simultaneously press for 3 seconds. Continue pressing the buttons until both columns are in the lowest position. When finished with the reset, the control box will make a “beep” sound and the buttons can be released. -
Page 6: Adjusting The Height
Press button until the desk reaches the preferred height. 4. Setting the Memorized Position TDH8P supports a maximum of 4 memory positions. How to memorize a position: Adjust the desk to the desired height. Press the preferred memory button (1 ,2 ,3 or 4), with either for 2 seconds. -
Page 7: Setting The Upper And Lower Height Limit
Hand Control Programming-TDH8P 5. Setting the Upper and Lower Height Limit Setting the upper height limit: (1) Adjust the desk to the preferred upper height limit. (2) Press buttons together for less than 3 seconds, holding and release button. (note 3) (3) Re-press for more than 3 times at a slow pace. -
Page 8: Presetting The Desk Starting Height
Hand Control Programming-TDH8P 6. Presetting the Desk Starting Height (1) Press button until the desk reaches its lowest position and then release button. Re-press button again for 5 seconds and the digital display will flash for 10 seconds. (2) Adjust the starting height number with the button. -
Page 9: Switching Metric And Imperial Unit
Hand Control Programming-TDH8P 7. Switching Metric and Imperial Unit (1) Press memory buttons 1, 2 and 4 for 5 seconds. (2) The digital display will show “C-I”. If no further instruction is input within 5 seconds, the system reverts to normal operation mode. -
Page 10: Restore Factory Setting
Hand Control Programming-TDH8P 8. Restore Factory Setting (1) Refer to Chapter 2-Reset: after the “beep” sound, press buttons together for 15 seconds, the control box will twice make a “beep” sound. (2) The settings below will restore to the original factory settings: Memorized position ... -
Page 11: Power Saving Function - Waking Up The Control
Hand Control Programming-TDH8P 10. Power Saving Function - Waking Up the Control The digital display automatically turns off if no buttons are pressed within 25 seconds. Press any button to light up the display again. The system goes into <0.1W standby mode if no buttons are pressed within 30 seconds.
Need help?
Do you have a question about the TDH8P and is the answer not in the manual?
Questions and answers