Harman Kardon SIGNATURE 2.0 Service Manual page 38

Signature 2.0 Processor/Tuner
10. Modified Traffic support to look for both "announce" and programming.
11. Added Traffic as a preset type.
12. RDS not supports TextA and TextB bit for displaying total of 128 character strings.
13. Detect new style DSP board and issue correct mode commands. Also enable DTS
modes.
14. Added new Dolby Digital commands for correct mixing of matrixed streams.
15. Fixed DTS flash bug.
16. Center boost value changed from +2 to +4.
17. Subwoofer speaker setup mute bug fixed.
18. Personal1 will only search presets, not the entire band.
19. Center mode status now displayed correctly on the OSD.
20. "Center Wide" mode now blends correctly into L and R.
21. Pro Logic volume shift now added correctly when auto-selecting Pro Logic mode.
22. Correct Stereo 3 downmixing when disabling surround speakers.
23. When cycling through Center modes, boost is no longer cumulative.
24. Fixed random characters on OSD when powering up with OSD display turned off.
25. Significantly enhanced front panel button response.
26. Selected analog record input no longer bleeds through during power up.
27. Obnoxious popping removed from power up sequence.
28. When speaker setting indicates small surrounds, the surround low pass info is no
longer mixed into either the fronts or subwoofer in a Pro Logic or other matrixed
mode.
29. RS-232 interface and external control software enabled.
30. "Debounced" sync signal to video board to get rid of annoying flashing when a weak
or no signal is present on video input.
31. When changing audio inputs from Souces menu, and a change is made from either
analog to digital or vice-versa, the current mode is changed to the first available
mode that is appropriate for the type of input selected.
32. Re-configure speakers for any stereo mode to remove the center speaker from the
setup.
The following code changes were made from ver 2.5 to create 2.5E of the
Signature 2.0.
1. When powering up main, initialize the video chip correctly to display a Blue screen
rather than black.
2. Correctly set mixer latches when toggling between Stereo and any matrixed mode.
The following code changes were made from ver 2.5E to create 2.6 of the
Signature 2.0.
1. Added menu entry in "Source Menu" for Video Detect. This allows the user to
configure each individual source to switch to a Blue Screen when a loss of video
sync pulses is detected, as in the default or "Auto" mode, or disable the detection
altogether in the "Off" mode. The "Off" mode is useful when a video source is used
that may exhibit video sync pulses that may be too weak for the Signature video
board to deal with correctly, causing the Blue screen to appear rather than the
selected video.
38
harman/kardon