Cisco Router And Security Device Manager - Cisco CISCO1751 Quick Start Manual

Figure 8
Kensington-compatible
Slot 1
OK LED
Figure 9
Figure 9
VIC
E&M
Example
If you install a VIC in both SLOT 0 and SLOT 1 of the router, the ports in each of these slots would be
numbered as follows:
SLOT 0—0/0 and 0/1
SLOT 1—1/0 and 1/1

Cisco Router and Security Device Manager

Cisco Router and Security Device Manager (SDM) is a web-based configuration tool that allows
you to configure LAN and WAN interfaces, routing, Network Address Translation (NAT),
firewalls, VPNs, and other features on your router. If SDM is installed on your router, configure
the router by following the instructions in the Cisco Router and Security Device Manager (SDM)
Quick Start Guide. If this document was not shipped with your router, you can obtain SDM and
instructions for installing it on your router from the following location:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
78-11259-05
Cisco 1751 Router Slot Numbering
WIC/VIC
locking socket slot 1
VIC
2FXS
1
SEE MANUAL BEFORE INSTALLATION
SLOT 1 OK SLOT 0 OK
Slot 0 WIC/VIC
OK LED slot 0
FDX/100/LINK LEDs
shows the VIC port numbering.
VIC Port Numbering
VIC port 1
1
SEE MANUAL BEFORE INSTALLATION
Console port
Model Cisco 1751
SLOT 1 SLOT 2
VIC
2FXO
0
CONSOLE
SLOT 0
FDX 100 LINK
AUX
10/100 ETHERNET
10/100-Mbps
Ethernet port
Ground
wire
Auxiliary port
VIC port 0
0
Cisco 1751 Voice-over-IP Quick Start Guide
Cisco Router and Security Device Manager
VIC
Power switch
slot 2
THIS SLOT
ACCEPTS
ONLY VOICE
INTERFACE
CARDS
1 0
SEE MANUAL BEFORE INSTALLATION
PVDM OK MOD OK SLOT 2 OK
+5, +12, -12 VDC
PVDM Slot 2
OK LED OK LED
MOD
Power
OK LED
socket
9