Frigidaire ECMK095-Navy Use & Care Manual page 5

Table of Contents

Advertisement

Available languages

Available languages

BEFORE FIRST USE & BREWING COFFEE
9. Allow all the co ee to drip from the brewing chamber into the mug before
removing the mug, but power switch is light .
Note: since co ee grounds absorb some water during brewing , the amount of
brewed co ee will be slightly less than the amount of water pure dint other
reservoir.
10. When the brewing cycle is complete , the indicator light will shut o and the
unit will not longer heat.
1
1. If brewing another mug of co ee at this time proceed to the brewing a second
mug of co ee section, when all brewing is complete, unplug the power cord
from the electrical outlet.
NOTE: ONCE THE START BUTTON IS PRESSED, THE COFFEEMAKER WILL
START THE BREWING CYCLE AND REMAIN ON UNTIL THE BREWING CYCLE
IS COMPLETE, TO INTERRUPT OR STOP THE BREWING CYCLE, YOU CAN
PRESS THE POWER SWITCH TO THE OFF MODE.
12. Note: The Start Button on this product is a thermally-operated activation
switch for starting a brewing cycle. Pressing it again after the start of a brewing
cycle. To interrupt a brewing cycle, power switch setting to 0,
If the indicator light comes "ON" when the product is first plugged in,
wait approximately 30 seconds for it to go "o " before using the product.
13.When you Long time need not, please power switch setting to 0.
Brewing a Second Mug of Coffee:
To brew another Mug of co ee, allow the Co eemaker to completely cool
(about three minutes) after the Indicator Light has shut o . Rinse the Mug and
the Reusable Mesh Filter with water. Repeat the brewing procedure.
WARNING: If the Co eemaker does not cool completely before reuse,
water placed in the Water Reservoir may overheat. This can cause steam to
escape, resulting in a risk of burns or personal injury.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecmk095-blackEcmk095-white

Table of Contents