Cisco 7505 Quick Start Manual page 15

Start and Configure the System
Perform a Basic Configuration Using Configuration Mode
At the reboot, the following example appears:
Any interface listed with OK? value "NO" does
not have a valid configuration.
Interface IP-Address OK? Method Status
Protocol
Ethernet0/0 unassigned NO not set down down
Serial1/0 unassigned NO not set down down
Step 1
Enter the configure terminal command at
the enable prompt to enter configuration
mode from the terminal, as follows:
Router# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
Router(config)#
Step 2 Enter the interface type slot/port
command at the enable prompt to enter
interface configuration mode, as follows:
Router(config)# interface serial slot/port
Router(config-if)#
Step 3
Press Ctrl-Z to exit configuration mode.
Step 4
At the # prompt, enter the copy
running-config startup-config command
to save the configuration to NVRAM as
follows:
Hostname# copy running-config startup-config
Your Cisco 7505 router is now minimally configured
and ready to use. If you want to modify the
parameters after the initial configuration, use the
setup command. To perform more complex
configurations, use the configure command. For
more information on additional interface
configuration and information on more specific
system configurations, refer to the Cisco 7500 Series
Installation and Configuration Guide.
13