Power Failure; Moving The Refrigerator - Haier HR-138A Operation Instructions Manual

Defrosting/Cleaning
Defrosting
The surface of evaporator ices up when the re-
frigerator is working. When the frost layer is thick
as 3mm, the refrigerator must be defrosted and
cleaned. Otherwise, it may results in lower efficiency
and high energy consumption.
Set the temperature at '0' position. After
defrosting, dry the water tray and then replace it in
the refrigerator. Reset the temperature regulator to
its original position.
Note
: Never use a sharp or pointed item to
defrost or loose the ice tray. Otherwise it's likely to
damage the surfaces of the evaporator and result in
the leakage of refrigerant. The manufacturer takes no
responsibility for cost of the reparation even the ap-
pliance is under warranty.
When a power failure is announced
No defrosting
Set the temperature regulator to the highest
setting.
No more fresh foods are to be stored in the
refrigerator.

Power failure

Do not open the door more often than necessary.
For a power failure not more than 3 hours, foods
in the refrigerator can be well stored even in
summer.

Moving the refrigerator

Unplug the appliance
Take out foods and dry the water tray before
moving the refrigerator.
Note
: Do not hold the refrigerator by its door and
the piping of condensor-That's dangerous!
.9.