Table of Contents
Advertisement
To configure SNMP parameters, complete the following steps:
Enter the SNMP configuration menu.
Step 1
Would you like to enter the SNMP configuration menu? [no]: y
Type y and press Enter.
The SNMP configuration dialog begins.
Step 2
Enable SNMP management.
Type y and press Enter.
Enable SNMP management? [no]: y
If you choose to disable SNMP management, skip the rest of this section and go to
Dependent Parameters
disabled.
Type the SNMP GET community name and press Enter.
Step 3
The SNMP agent that resides inside the SCE 2000 will respond only to GET requests that use this community string.
Enter SNMP GET community name:
Note that there is no default for this parameter.
Assign an access list to restrict the SNMP management stations that may use this GET community.
Step 4
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow
all:
The maximum number of GET communities is 20.
Step 5
To add more entries, type y and press Enter
•
Would you like to add another SNMP GET community? [no]:y
•
Enter up to 20 SNMP GET communities as described in step 3 and step 4.
When all entries have been added, press Enter
•
Would you like to add another SNMP GET community? [no]:
Type the SNMP SET community name and press Enter.
Step 6
The SNMP agent that resides inside the SCE 2000 will respond only to SET requests that use this community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Step 7
Assign an access list to restrict the SNMP management stations that may use this SET community.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow
all:
Step 8
The maximum number of SET communities is 20.
To add more entries, type y and press Enter
•
(on page 31). The rest of the dialog is not presented, as it is irrelevant when SNMP management is
Step 9: Configuring the Topology-
29
Advertisement
Table of Contents
