Page 2
VERTICAL MOUNTING we strongly recommend that installation be way, will provide the best sonic reproduction in Position BassLink+4 so that the heatsink is facing Note: Place BassLink+4 (with its feet) so the entrusted to a qualified professional. Although the 60Hz to 100Hz range because the woofer down and the bottom of the unit is up.
Page 3
Connect the RJ11 cable the following installation tips: REMOTE LEVEL control as a template, mark and between the RJ11 receptacle on the BassLink+4 drill holes in the mounting surface. Attach the and the receptacle on the REMOTE LEVEL control •...
Page 4
Connect the input signal wires according to If your source unit provides two line-level outputs operate properly, the speakers and input wires BassLink+4 is equipped with four line-level Figures 8a through 8d. and two speaker-level outputs, you may connect MUST be connected in proper polarity! (RCA) inputs and four speaker-level inputs.
Page 5
PHASE CONTROL: Use this switch to invert amount of bass to suit your preference. proper adjustment of the Phantom Center circuit BassLink+4 is operational. the phase of BassLink+4’s subwoofer output. according to your car and your preference, using PHANTOM CENTER: the setup CD.
Page 6
The Phantom Center circuit provides four Tracks 5 through 16 are music tracks. There SUBWOOFER LEVELS used in Step 3, turn BassLink+4’s Gain control tuning selections: Off, 1, 2 and 3. These settings are three excerpts of songs and each excerpt...
Page 7
AUTO TURN ON is set to ON. that follow (Tracks 18–20) to check your work. all input connections on BassLink+4 and BassLink+4 will remain on for another 5 to 10 source unit. minutes after sensing that audio signals are not •...
Need help?
Do you have a question about the BassLink+4 and is the answer not in the manual?
Questions and answers