Detergent and Rinse Aid
Detergent specifically intended for use with dishwashers must
be used.The dispenser must be refilled before the start of each
wash cycle following the instructions provided in the "Wash Cycle
Table ".The detergent dispenser is located on the inside panel
Loading the detergent
To open the "A" cover on the dispenser,press the "B" button.The
detergent for the wash cycle should be poured into the "C"
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:To facilitate closing the cover, remove any excess
detergent on the edges of the dispenser.
This product makes dishes sparkle and helps them to dry with-
out spotting.The dispenser is located on the inside panel of the
door and should be filled after every 80 wash cycles.
Loading the Rinse Aid
Regardless of the type detergent dispenser installed on your
appliance,you must proceed as indicator below when loading
the rinse aid.
To open the dispenser,turn the "C" cap in the anti-clockwise
direction and then pour in the rinse aid,making sure not to overfill.
The amount of rinse aid used for each cycle can be regulated by
turning the "F" dose adjustor,located beneath the "C" cap, with
a screwdriver.There are 6 different settings; the normal dosage
setting is 3.
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs , the
dosage adjustor should be turned to a higher setting.
If the dishes have white streaks,turn the dosage adjustor to a