Dishwasher Will Not Fill - Haier HDB18EB User Manual

Dishwasher is leaking:
• Dishwasher is not properly leveled.
You need to place the dishwasher on a flat hard surface. Avoid an uneven
surface.
• Make sure the dishwasher is properly leveled . (See the installation instructions)
• Do not overfill the detergent or the rinse agent dispenser because it will cause
oversudsing and overflowing.
• Do not use regular type hand or dish washing detergent in the detergent
dispenser. These types of detergents are not recommended for dishwasher use.

Dishwasher will not fill:

• Check the water supply.
Make sure that the water supply is in "ON" position.
• Check water pressure.
Make sure the water pressure is at the proper level. (Between 20 – 120 PSI)
Water found under the filter:
• A small amount of water found under the filter area after completion of the cycle
is normal.
Detergent found in the compartment:
• Do not load items too close to the detergent compartment. This may block the
automatic release of the detergent.
• Do not use old or caked/dried detergent in the compartment because it will not
dissolve properly and will leave a sandy residue on dishware.
Dishwasher is running for too long:
• The temperature of incoming water is below 120˚F. Raising your water heater
setting will help to shorten the time of operation.
• Call the Haier Customer Satisfaction Center if this does not resolve the problem.
English
26