Haier HDB18EB User Manual page 27

English
Water
Draining Problem:
• Check the level of the drain hose. The drain hose should be positioned above the
drain in order to drain properly. Make sure it is on a high drain loop (20") above
the sub floor or floor.
• If the drain hose is bent or shrunken, it may affect water draining.
• If water can not be drained out smoothly, the dishwasher operation will be
disturbed and it may stop in the middle of the cycle.
• Make sure that the wash cycle is fully completed before you opened the
dishwasher door. If the wash cycle is not completely finished, allow the cycle to be
completed and check again.
• Make sure that the air gap is not blocked.
• If the unit is connected to a garbage disposer, make sure that it is not full. If it is,
you need to empty it.
• Check for any type of blockage near the drain and dishwasher filter area.
• If the water backs up into the sink, you need to check the garbage disposer and the
trap for blockage.
• It is normal to find some water in the sump area near the drain.
Steps of draining the water out of the tub:
1) Shut off the unit power and wait a few seconds.
2) Turn the knob to the "RINSE & HOLD" wash-cycle button.
3) Turn the power on again and you will hear a water draining noise.
4) Let the water drain out for approximately 30 seconds and shut off the unit power.
5) If there is still some water in the tub, repeat steps 1-3 again until the water is
completely drained.
6) If you still notice excessive water present in the tub after completing these steps,
call the Haier Customer Satisfaction Center for further assistance. 1-877-337-3639
25