Cisco Network Device 7010 Replacement Instructions Manual page 7

Cisco systems network device instructions manual

Hide thumbs Also See for Network Device Cisco 7010:

Table of Contents

If these conditions are not true, for instance, if you must remove a rack-mounted chassis

Note

before you can install the new chassis, you must disconnect all power and network interface cables.

Also, ensure that your new chassis allows sufﬁcient clearance for maintenance: to remove and

replace processor modules and interface cables at the interface processor end, and to access the

internal components at the noninterface processor end. Figure 4 shows the chassis footprint and the

clearance required to remove or install each of the major components.

Figure 4

Chassis Footprint and Clearance Requirements for Maintenance

2 in.

(5.08 cm)

Chassis foot C

14.25 in. (36.20 cm)

Power supply width

14.60 in. to ears (37.08 cm)

Noninterface processor end

Interface processor end

Interface processor width

14.55 in. (36.96 cm)

Chassis width

17.50 in. (44.45 cm)

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Prerequisites

1.25 in. (3.18 cm)

Table of Contents

7505 Chas-7010-dc=Chas-7010-ac=Chas-7505-dc=Chas-7505-ac=