Timer On/Off Operation - Haier HSU-09HV03 Operation Manual

Operation

Timer On/Off Operation

Remote Controller
o
C
ON
AM AM
TEMP
ON
OFF
SWING FAN
MODE HEALTH AIRFLOW SLEEP
HEALTH FRESH
CLOCK SET
4
TIMER STERILIZE
LIGHT LOCK
RESET CODE
Hints:
After replacing batteries or a power failure happens, time setting should be reset.
Remote controller possesses memory function, when use TIMER mode next time,just
press SET button after mode selecting if time setting is the same as previous one.
Set clock correctly before starting TIMER operation.
1. After unit starts, select your desired operation mode
Operation mode will be displayed on LCD.
2. Timer mode selection
Press TIMER button to change TIMER mode. Every time
the button is pressed, display changes as follows:
Remote controller:
TIMER ON
Then select your desired TIMER mode (TIMER ON or
TIMER OFF). "
3.Time setting
Press HOUR
Every time the button is pressed, time setting
increases 1 min, if kept depressed, it will increase
rapidly.
Every time the button is pressed, time setting
decreases 1 min, if kept depressed, it will decrease
rapidly.
It can be adjusted within 24 hours.
4.Confirming your setting
After setting correct time, press SET button to confirm
" "or" "on the remote controller stops flashing.
Time displayed: Unit starts or stops at x hour x min.
TIMER ON or TIMER OFF).
5.Cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
16
TIMER OFF TIMER ON-OFF
"or " "will flash.
button.
BLANK