Maintenance; Cleaning; Duty To Inform And To Instruct - G-U PRIME OFFICE 2170 Installation, Operating And Maintenance Instructions

Installation, operating and maintenance instructions
Radio locks PRIME OFFICE 2170 (EN 179) for toughened glass doors
9.3

Maintenance

Emergency exit devices must be inspected for proper condition and functioning at least once a month.
The forces required to release the emergency exit device must be measured with a dynamometer and recorded. Major deviations from the
values recorded at initial installation are not acceptable.
The fittings must be checked for tight fit and wear. If necessary, fastening screws must be retightened and worn components exchanged by a
specialist company.
Ensure that strikes are not jammed or filled with dirt. Verify, if all components still comply with the originally specified, delivered and approved
components, and that no other locking device has been mounted to the door subsequently.
All locking and moving components of the exit device must be greased with acid-free lubricant (e.g. LUMO special grease 8559/1 from
Zeller+Gmelin) at least once a year or more frequently depending on the stress. The rear of the latchbolt must be greased once a year at
least.
The radio lock PRIME OFFICE 2170 is operated with a special 3.6 V AA battery which offers a performance of 150,000 cycles at continuous
operation. In order to ensure the reliable functioning of the lock, it is necessary that the battery should be exchanged as soon as one of the
two low-battery alarm levels is reached (see chapter 3) or after 2 years (for approved battery types see chapter 1.1 Technical specifications
Power supply).
9.4

Cleaning

Clean covers exclusively with a soft cloth using a mild, ph-neutral cleaning agent in diluted form. Never use agressive, acidic detergents or
scouring agents, or agents containing corrosive ingredients.
9.5

Duty to inform and to instruct

In order to comply with the informational and instructional duties prescribed by the German Product Liability Act, the following documents and
services are made available to specialist dealers, locksmiths, architects, planners, fabricators and end users upon request:
- Catalogues, brochures, tender specifications, quotation documents,
- EN 12209, DIN 18251, DIN 18252, EN 179, etc. (exclusive distribution of DIN standards by Beuth-Verlag GmbH, Berlin),
- Assembly, operating and maintenance instructions,
- Technical support directly from us or from our consulting field service.
- For the appropriate selection, installation, operation, and maintenance of locks and fittings,
architects and planners are advised to request from us and observe all required product information,
specialist dealers are advised to follow the appropriate product information and references in the catalogues, and to request all necessary
instructions from us in order to forward them to the fabricators/installers.
fabricators/installers are advised to follow all product information, and to request from us operating and maintenance instructions in order
to hand them out to customers and users.
17 0-45648-3E-0-GB, modif. 1, sheet 17/20, Mod. No. G24578, www.g-u.com 01/2011