Operation Mode - Haier AD362AMBEA Instruction Manual

OPERATION
TIMER ON-OFF
(1)After unit start, select your desired

operation mode

Operation mode will be displayed on LCD.
Power indicator lights up.
(2) Press TIMER button to change TIMER
mode
Every time the button is pressed, display changes as follows:
ON
OFF
ON
Select .
OFF
(3)Time setting for TIMER ON
Press TIME button.
Every time the button is pressed, time increases 10min.
If button is kept depressed, time will change quickly.
Every time the button is pressed, time decreases 10min.
If button is kept depressed, time will change quickly.
Time will be shown on LCD.
It can be adjusted within 24hours.
AM refers to morning and PM to afternoon.
To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can
be achieved.
ON
blank
OFF
12
MODE FAN
HEALTH
TEMP
3
CLOCK
2
SET
TIMER
ON OFF HEAT FILTER RESET
4
AM
PM
ON/OFF
(4) Time confirming for TIMER ON
After time setting, press TIMER button to confirm.
"ON" stops blinking, While "OFF" starts blinking.
Time displayed: Unit starts at Xhour X min.
(5)Time setting for TIMER OFF
Follow the same procedures in "Time setting for
TIMER ON".
(6)Time confirming for TIMER OFF
After time setting, press SET button to confirm
"OFF" stops flashing.
Time displayed: Unit stops at X hour X min.
SWING
***
SET
SLEEP
6
5
RESET
1