Haier AD242AMBAC Instruction Manual page 11

OPERATION
AUTO RUN, COOL,HEAT and DRY operation
Recommendations
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display
(Not Timer setting). Power indicator lights up.
(2) Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
AUTO COOL
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button
Every time the button is pressed, temp. setting
increases 1 C.
If button is kept depressed, temp.setting will
increase quickly.
Every time the button is pressed, temp. setting
decreases 1 C.
If button is kept depressed, temp. setting will
decrease quickly.
Unit will start running to reach the temp. setting
on LCD.
Use COOL in summer.
Use HEAT in winter.
Use DRY in spring,autumn and in damp climate.
DRY HEAT FAN
MODE
AUTO
2 TEMP
3
CLOCK
SET
TIMER
C
FILTER RESET
AM
ON/OFF
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
LOW
Unit runs at the speed displayed on LCD.
In HEAT mode, warm air will blow out after a short
period of time due to cold-draft prevention function.
In DRY mode, when room temp. becomes 2 C higher
than temp. setting, unit will run intermittently at LOW
speed regardless of FAN setting.
(5) Unit stop
Press ON/OFF button.
Only time and room temp remains on LCD.
All indicators go out.
Vertical flap closes automatically.
Hints
Wire controller can memorize each operation
status. When starting it next time, just press
ON/OFF button and unit will run in previous
status.
10
FAN SWING
4
SET
SLEEP
RESET
5
1
AUTO
MID HIGH AUTO