Download Print this page

HP Netelligent 2008 User Manual: Supported Mibs

Hp netelligent 2008: user guide.
Hide thumbs

Advertisement

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SNMP over IP requires the full support of the UDP/IP protocol stack, which
includes address resolution protocols, a control and error message protocol, and
IP fragmentation. ARP (Address Resolution Protocol), RARP (Reverse Address
Resolution Protocol), and BOOTP provide address resolution capabilities. ARP
allows the dynamic mapping of IP addresses to a given hardware address. The
Netelligent 2008/2016 repeater supports ICMP (Internet Control Message
Protocol) as the standard for error and control message exchanges. The repeater
supports IP fragmentation up to a maximum packet size of 1520 bytes.

Supported MIBs

The 2008 and 2016 repeaters support the following MIBs:
RFC1213
of TCP/IP-based Internets (MIB II); the firmware supports the following
groups in MIB II:
RFC1516
Repeater Devices (technically part of MIB II).
NWS2000 MIB
Novell Repeater MIB
Novell's NMS.
Management Information Base for Network Management
System Group
Interfaces Group
Address Translation Group
atPhysAddress is supported for read only
atNetAddress is supported for read only
IP Group
ICMP Group
UDP Group
SNMP Group
Definitions of Managed Objects for the IEEE 802.3
rptrReset does not perform an actual repeater reset
rptrNonDisruptTest does not perform an actual test
This MIB is required to support
Netelligent 2008/2016 10Base-T Repeater User Guide
4-37

Advertisement

   Also See for HP Netelligent 2008

This manual also for:

Netelligent 2016

Comments to this Manuals

Symbols: 0
Latest comments: