Download Print this page

HP Netelligent 2008 User Manual: Rj-45 Autopolarity Reversal; Supported Frame Types; Supported Protocols

Hp netelligent 2008: user guide.
Hide thumbs


. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Administration and Management
The security feature provides further network security by restricting access to
the nw2IntrusionPortStatus and nw2IntrusionPortMACAddress MIB variables,
which prevents any changes to the intrusion table. To use the security feature,
you must use an SNMP manager that supports security.

RJ-45 Autopolarity Reversal

Autopolarity reversal is a port-level programmable feature provided with Boot
v1.30. When enabled, autopolarity reversal can automatically invert the polarity
of the port to correct a wiring error. Boot v1.30 enables Autopolarity reversal
before it starts its BOOTP/RARP sequence. If Runtime v1.30 is running with
an older version of Boot, it enables Autopolarity reversal when the Boot
sequence completes and Runtime is executing. Resetting the repeater disables
Autopolarity reversal.

Supported Frame Types

The Netelligent 2008 and 2016 repeaters support the following frame types:

Supported Protocols

The repeater supports both the IP and IPX protocol stacks for SNMP
management. The VT100 management interface is also supported over the
TCP/IP stack. All pertinent frame types are supported for each of these
protocol stacks.
802.3 RAW: IPX
802.2 (TYPE II): IPX
802.2 SNAP: IPX and IP
Ethernet_II: IPX and IP


   Also See for HP Netelligent 2008

This manual also for:

Netelligent 2016

Comments to this Manuals

Symbols: 0
Latest comments: