Download Print this page

HP Netelligent 2008 User Manual: Connecting Power

Hp netelligent 2008: user guide.
Hide thumbs

Advertisement

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-14
Installing the Repeater

Connecting Power

Follow these steps to connect the repeater to power:
1. Plug the power cord into the power connector on the back of
2. Insert the three-pronged plug on the power cord into a non-switched,
Figure 3-12. Connecting the Power Cord
NOTE: The power outlet should be near the repeater and easily accessible.
3. When you plug in the power cable, verify that the repeater performs the
To power down the repeater, disconnect the male connector from the wall outlet
or power strip. Do not disconnect the female connector from the repeater to
power down the repeater because it is not a tested disconnect.
the repeater.
grounded power outlet on a wall, a power strip, or a grounded
extension cord.
Power Cord Connector
self test (described in the following section) to confirm that the repeater is
operating correctly.

Advertisement

   Also See for HP Netelligent 2008

   Related Manuals for HP Netelligent 2008

This manual also for:

Netelligent 2016

Comments to this Manuals

Symbols: 0
Latest comments: