Download Print this page

HP Netelligent 2008 User Manual: Setting Jumpers For A Bnc Amc

Hp netelligent 2008: user guide.
Hide thumbs

Advertisement

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTES:
The MEP is the 17th logical port on the repeater.
Link test is available for the fiber optic AMC (hardware is always enabled, but
firmware can effectively disable link test), but not for the AUI or BNC AMCs.
Figure 3-3. Optional Alternate Media Connectors

Setting Jumpers for a BNC AMC

If you install a BNC AMC, but do not connect a cable, you must set the
connector board jumper to disable the port. You can also use an external
terminator on this port. If you use a terminator, set the jumper to ON for
future connections.
NOTE: If there is no connection or external terminator at the BNC port, the jumper
must be set to OFF; otherwise, excessive collisions will occur and adversely affect
network performance.
Figure 3-4 shows the AW1 jumper settings.
Optional Alternate Media Connectors
BNC Connector
(Thinnet)
AUI Connector
Netelligent 2008/2016 10Base-T Repeater User Guide
Fiber Connector
(10BASE-FL)
3-3

Advertisement

   Also See for HP Netelligent 2008

   Related Manuals for HP Netelligent 2008

This manual also for:

Netelligent 2016

Comments to this Manuals

Symbols: 0
Latest comments: