Setting Ethernet Speed And Duplex Parameters - Cisco 3522 BRI Installation And Upgrade Manual

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3500 Gateway
•
•
Step 12 Allow the unit to complete the reboot process. A new emulator session begins.
Close the terminal emulator session.
Step 13

Setting Ethernet Speed and Duplex Parameters

Use the serial port to set the Ethernet speed and duplex parameters that you want the Cisco Unified
Videoconferencing 3500 Gateway to use.
Procedure
Access the gateway through the serial port and start a terminal emulator session.
Step 1
Note
When the message "Press any key to start configuration" appears on the screen, press any key within 6
Step 2
seconds.
The network configuration Main menu appears.
At the prompt, enter A to display the Advanced Configuration menu and press Enter.
Step 3
The Advanced Configuration menu appears.
At the prompt, enter 3 to select "Change LAN port Settings" and press Enter.
Step 4
At the prompt, enter the number or letter for one of the following:
Step 5
•
•
•
•
•
•
Note
Press Enter.
Step 6
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3522 BRI Gateway and 3527 PRI Gateway Releases 5.6 and 5.7
OL-17010-01
How to Perform the Cisco Unified Videoconferencing 3500 Gateway Unit Initial Configuration
Convert the subnet mask IP address to hexadecimal notation, type the hexadecimal number at the
prompt, and press Enter.
For example, for the subnet mask 255.255.255.0 the hexadecimal value you type is FFFFFF00.
You can use the computer's desktop calculator to convert the subnet mask ID to hexadecimal
Note
notation.
If a subnet mask is not used, press Enter.
If the gateway is already running, you need to reboot or restart the device.
1 - 10Mbps Half Duplex
2 - 100Mbps Half Duplex
3 - 10Mbps Full Duplex
4 - 100Mbps Full Duplex
5 - Auto
Q - Quit
We recommend that you select "5 - Auto" here and also set the Port settings option to "Auto" in
the gateway web user interface at Gateway > Device > Addressing.
2-9