Changing The Flicker Filter; Turning Camera Sounds On And Off; Configuring Instant Review - HP iPAQ hw6900 User Manual

The resolution settings to choose from are:
●
160 x 120 pixels
●
320 x 240 pixels
● 640 x 480 pixels
●
1280 x 1024 pixels (default)
NOTE
longer to send by Multimedia Messaging Service (MMS), e-mail, or infrared.

Changing the Flicker Filter

Fluorescent light bulbs flicker due to alternating current. The electronic shutter on the camera is not
immune to this flickering. Use the Flicker Filter setting to filter out flickering, sometimes called banding.
1. Tap the Settings tab > Flicker Filter > Change button.
2. Make the necessary changes, and then tap OK.
NOTE
The flicker filter settings to choose from are:
●
Auto (default) — automatically adjusts for the best picture.
●
50 Hz — filters banding caused by fluorescent light bulbs operating on an alternating current at 50
Hz.
●
60 Hz — filters banding caused by fluorescent light bulbs operating on an alternating current at 60
Hz.

Turning Camera Sounds On and Off

1. Tap the Setup tab > Camera Sounds > Change button.
2. Tap either On or Off.
3. Tap OK.

Configuring Instant Review

Instant Review determines how long an image is available after it is captured.
1. Tap the Setup tab > Instant Review > Change button.
2. Tap either Off, 2, 4, or 6 seconds.
3. Tap OK.
ENWW
The larger the resolution you choose, the more storage space required and it may take
To reset the camera settings, tap the Reset button.
Changing Camera Settings 81