Surface-Mount Installation - GE KTR-11 Installation Manual

6 KTR-11 Face/Badge Reader
Installation Manual

Surface-mount installation

You can also mount the unit on a wall surface. To surface-mount the unit, do the following:
1. The KTR-11 is secured to the wall flange by four bolts, two in each side wall (Figure 4). Locate and
remove these bolts. You may need to remove the cameras and the mirror assembly to gain access.
2. Lift the KTR-11 unit out of the flange.
3. Place the wall flange against the wall so that the bottom is 47 in. (119 cm) from the floor. Make sure
the flange is level and mark the location of the four mounting holes on the tabs at the rear of the flange.
4. Prepare the mounting holes on the wall for the appropriate mounting bolts.
5. Secure the flange to the wall.
6. Bring wires and cables into the KTR-11 through the appropriate openings.
7. Remount the KTR-11 in the flange using the four bolts removed earlier.
8. Reinstall the cameras and/or the mirror assembly if removed.
Note: It is possible that during shipping the wall flange may have shifted out of square. When leveling the flange, be
sure that 90-degree angles are maintained at the corners.
Figure 4. Surface-mounting the KTR-11 using a KTR-92 wall flange
KTR-92 wall flange
47 in. to floor
(1.19 m)