S&G Titan Quick Start Instructions

Lock / Unlock
Indicator Tab
Enter default "Master Code"
Open Lock
1 2 3 4 5 6 #
1. Each time you press a number, letter, or other character on the keypad of your electronic safe lock beeps and the red LED flashes. The symbols in examples show
the number of beeps you hear.
2. Your lock is currently in Multiple User Mode where only one code is required to open. If you want the lock to operate in Dual Control Mode where two codes are
required to open, then you must switch modes before changing or adding codes or programming any features of the lock. Failing to do so will result in not being
able to set the lock to Dual Control in the future. Once the lock is set to Dual Control it will not be possible to return it to Multiple User Mode.
3. Error Beep: A long beep (called a BRAP) during any programming sequence indicates you have made an error. Restart the sequence from the beginning.
4. Error Penalty: If you enter five incorrect codes in a row within a ten minute period, the lock starts a ten‐minute penalty time. If you press any button during this
time, you will hear two BRAPs, and the lock will not open. You have no recourse other than to wait ten minutes before entering a valid code to open the lock.
Titan Direct‐Drive Lock – Quick Start Instructions
Input correct
code then
rotate ring to
Install a 9 volt alkaline battery, Duracell is recommended. To install the
battery, pull the lock/unlock indicator tab out slightly and turn the ring
counterclockwise (left) to reveal the battery storage area and battery
connector. Attach the battery then push the ring back toward the base
while turning clockwise (right). The ring will 'click" when properly seated.